dinavahi@amelia.nas.nasa.gov (Suryaprasad P.G. Dinavahi) (07/27/89)
Hello netlanders!
I am having problems getting GSS-Terminal getting to work on my 3b1. I would
appreciate any help/suggestions.
Along with my 3b1, I h have inherited GSS Driver set and a
GSS-Solutions GSS-Terminal diskette. I am going to summarize my problem below.
1. Installed GSS Drivers Vers. 1.01
2. Installed GSS Solutions GSS-Terminal Ver. 1.02 as per the instructions in
the accompanying manual.
3. Now I had configured the hardware as below:
a) In the GSS-Terminal set up, there are two options /dev/tty000 and /dev/ph1
Not knowing what the tty000 is for, I chose /dev/ph1 since I want to
communicate with out side computers and would like to use the graphics
capability.
b) Telephone setup. I have only one telephone line at home. First I
configured the line 1 and tried to use GSS-Terminal but no luck.
So now I configured line 1 as voice and line 2 as data and connected the
line 2 to the telephone line.
4. When I tried now to create the GSS-Terminal, I get message
" Requested Port is busy."
I would appreciate help regarding how I can use this GSS-Terminal to emulate a graphics (TEKtronix 4014 say) terminal so that I can use it to plot while
connected to out side computers.
If this is not possible, could some one let me know where I can get a
graphics emulator for the 3b1?
Thank you very much
Surya Dinavahi
email: dinavahi@amelia.nas.nasa.gov