jacksonR@batman.moravian.EDU (Ron Ford Jackson) (01/08/90)
a friend of mine has a 6300+ and wants to add a VGA board. he was told this could be accomplished by merely disabling the existing display controller. sound too easy? :-) ok, the display controller is supposedly disabled by removing the 7400 at position H-6. pin 6 is then tied low (pin 6 to 7), and the remaining outputs are tied high (pins 3, 8, 11, to 14). it's a Rev P4 board. his objective was to avoid purchasing the bus converter kit. of course, it doesn't seem to work. or, at least... perhaps there is more involved? could anyone tell us what else needs to be done? i have some theories; but, they're all real scary. also, the VGA board is currently set to 8-bit. and, it appears that the 16-bit expansion bus on the 6300+ is not the standard 16-bit AT expansion bus. since we have been unable to locate the pin-outs for the 6300+ bus, we don't know the difference. could some kind soul please enlighten us? thanks, ron jackson CSNET / INTERNET: jacksonR@moravian.edu BITNET: jacksonR%moravian.edu@relay.cs.net UUCP: ...!rutgers!liberty!batman!jacksonR