fmcgee@cuuxb.ATT.COM (~XT6561110~Frank McGee~C23~L25~6326~) (01/09/90)
> (Note: The manual doesn't say, and I don't have a machine with > the shrouds removed at the moment, so I can't tell you which > ram bank is 0 or 1; using the switch settings and common > sense, it is not too difficult to figure out...) > I just looked at my notes -- the first two rows are bank 0 > (possibly soldered), the second two rows are bank 1. RAM bank 0 is soldered in on most 6300's (if not all ?) and bank 1 is socketed.... Also, I don't know if you mentioned in your previous post that dip switch bank 0 is at 7T on the bottom of the motherboard and dip switch bank 1 is at 7W. FYI, I had the cover off so that I could try a VDC 600 (Paradise VGA Plus card). It worked with the motherboard video disabled (jumper at W1 on the video card over the lower two pins) and dip switches 5 and 6 set to "on" on switch 1. Gotta have ROM BIOS version 1.43 too.....And of course AT&T doesn't support it (but it should work for you too). Hope this helps you out, -- Frank McGee, AT&T Entry Level Systems Support attmail!fmcgee (preferred) att!cuuxb!fmcgee (those that can't reach attmail)