sbw@tapest.UUCP (Steve Wampler) (03/01/90)
I finally figured out how to get the 4014 emulating async_main to run at 9600 baud (I forgot about '/usr/lib/uucp/L.sys' in this day of 'Dialers'...) Now, this async_main seems to know about 19200 baud (it displays it in some tables). Unfortunately, (so nearly as I can tell, anyway) /etc/ph doesn't, and quits with an 'Illegal baud-rate' message before turning the line over to async_main. Sigh, I admit I'm greedy, but 9600 baud is too slow. Does anyone have any suggestions on how to get /etc/ph to accept 19200 baud? Or is there a way to run async_main w/o going through /etc/ph. (Heck, I can hand dial the number if I can just talk with my TB+...) On a related note - are their any performance reasons for picking either tty000 or for picking tty001 (combo board) to hang the TB+ off of? Right now it's on tty000, should I switch? (Running 3.51m) Thanks for any help! -- Steve Wampler {...!arizona!naucse!tapest!sbw} {...!ditka!tapest!sbw}