dastrout@miavx1.acs.muohio.edu (Yendor) (04/10/90)
In article <69900001@p.cs.uiuc.edu>, goldsten@p.cs.uiuc.edu writes: > I have an Apple Duodisk with which I want to adjust the speed of > the drives but after taking it apart somewhat I can't find the > screw to adjust the speed. Can anyone tell me where it is located? > Thanks, > Arthur > > ------------------------------------------------------------------- The speed adjustment screw is a small plastic pot. located in the bottom of the drives. You must remove the case bottom, and look at each drive. Toward the back of each drive there is a small hole. Inside, there is a screw. It's deep !!! It's also very soft. Use a jeweler's screwdriver, and be carefull! I have torn one up, and it's a bitch to replace. You should do this with a good program ( I use Copy II+, V9.0). It doesn't take alot of movement to adjust. One other hint: Slow #2 drive slightly (maybe 200.5 ms), and it will help when you are doing a bit copy that requires nybble counting. (copy 1 to 2 of course). Dave Strout dastrout.miavx1.acs.muohio.edu 513-523-1319