m2@insyte.UUCP (Mike Arena) (05/19/89)
We have an original LaserJet printer (with only 59K of memory) and would like to upgrade it to be able to do full page 300x300bpi graphics. I saw an add for a cartridge called JetMemory which had 1.5MB from a company called Computer Peripherals, Inc. Unfortunately, there was no address or phone number given. If anyone has any information about this company or its products, please email it to me. Also, is it possible to upgrade the motherboard in the LaserJet itself? -- Michael J. Arena (617) 965 8450 | UUCP: ...harvard!linus!axiom!insyte!m2 Innovative Systems Techniques | ...harvard!necntc!lpi!insyte!m2 1 Gateway Center, Newton, MA 02158 | ARPA: insyte!m2@harvard.harvard.edu
henry@utzoo.uucp (Henry Spencer) (05/24/89)
In article <223@insyte.UUCP> m2@insyte.UUCP (Mike Arena) writes: >...is it possible to upgrade the motherboard in the LaserJet itself? No. Once upon a time you could buy an LJ -> LJ+ upgrade, but that was a brain transplant that replaced the entire board. The LJ board isn't designed to be field-upgradeable, and there is also the little problem that there is no documentation on it. (The LJ/LJ+ service manual treats the board as a mysterious black box.) This is kind of silly, since in principle it's just new RAMs and new ROMs, but my recollection (from the last time I did the brain transplant) is that the LJ and LJ+ boards are laid out somewhat differently, i.e. they may have made other changes. >I saw an add for a cartridge called JetMemory which had 1.5MB... Beware that the fine print in the specs for those things often says "for LJ+ or LJ2 only". I assume this is because of stupid firmware in the LJ that isn't up to handling strange-looking cartridges. -- Van Allen, adj: pertaining to | Henry Spencer at U of Toronto Zoology deadly hazards to spaceflight. | uunet!attcan!utzoo!henry henry@zoo.toronto.edu