chuqui@nsc.UUCP (Chuq Von Rospach) (04/23/84)
Has anyone out there written a post processor for ditroff for the QMS
laser printers? I don't like rewriting the wheel if I can help it. It looks
like I can get it up by using the CAT post processor and the QCAT
translator, but that seems like a significant efficiency dig that I'd like
to avoid if I can.
Has anyone out there integrated a QMS (or any laser printer, for that
matter) into the 4.2 Spooler? It looks like a fairly straightforward setup,
but if you know of a trap for the unwary, I'd appreciate hearing about it.
chuq
--
From under the bar at Callahan's: Chuq Von Rospach
{amd70,fortune,hplabs,menlo70}!nsc!chuqui (408) 733-2600 x242
Never give your heart to a stranger, unless you are sure that you are dead.