shawn@ACC.ARPA (02/26/86)
to: finholtAc.cs.cmu.edu(couldn't send to you so am posting) re: m-100/KAYPRO hookup There is a program called TERM that you should be able to use if you set the console up (CON:) to be the serial port (using CONFIG) also use CONFIG to set up the required baud-rate if different than "normal" (whatever that is). You should then be able to "run" the KAYPRO from the serial port. I don't know if this will allow binary transfers but should be OK for ASCII. There is also a users group for the M-100 users. The moderator is -drew- and the address is on the ARPA net (as well as some others) info-laptops-request@mit-oz the net itself is the same less -request. They have message and program archives, and seem very knowledgable. I hope this gets you what you need. I don't know why I couldn't get to your address but then I'm NOT a 'net person'. shawn@acc.arpa ------