kevinb%sdcsvax@sdcsvax.ARPA (02/26/86)
I am trying to get some docs on some S-100 boards made by
California Computer Systems, of 250 Caribbean Drive, Sunnyvale,
CA regarding some boards I bought to upgrade my venerable IMSAI
system. When I tried to call them at (408) 734-5811, I got a Ma
Bell "this # disconnected" message. Would anyone in the know
please contact me at the below address and tell me if they moved
or went belly-up? Any info would be appreciated.
I am also looking for an overlay for MEX, MDM7xx, or any other
programs available using the CCS 2719 2 serial / 2 parallel I/O
board, and am looking for info on the CCS 2805 Terminator /
Wallclock board, which I am planning on using in an RCP/M. If CCS
still exists and I can get a valid phone number / address, I will
be ordering the manual on the thing from them if available.
One last thing; has anything special been done with a CCS 2810
& 2422 board combination? We down here are especially looking for
interesting things done with the a custom BIOS, ie. CP/M 3+,
banking, ZCPR or Z-DOS , and MP/M implementations. We are trying
to do some interesting things with them, and would appreciate it
if any help or programs were sent our way. We are planning to
archive all info we get, and will be more than happy to
retransmit as needed.
Thanks,
Kevin Belles
Kevin Belles
AVALON I
4037 34th Street, Ste 4
San Diego CA 92104
(619)282-5661 eves
Kevin J. Belles - UUCP {sdcsvax,ihnp4!gould9,noscvax,cbosgd}!crash!kevinb
~~~~~ ~~ ~~~~~~ - ARPA crash!kevinb@{ucsd,nosc}.ARPA
Disclaimer: Anything I may say is my opinion, and does not reflect
the company I keep. KjBkevin@tolerant.UUCP (Kevin Flory) (03/06/86)
> Kevin Belles writes: > > One last thing; has anything special been done with a CCS 2810 > & 2422 board combination? We down here are especially looking for > interesting things done with the a custom BIOS, ie. CP/M 3+, > banking, ZCPR or Z-DOS , and MP/M implementations. We are trying > to do some interesting things with them, and would appreciate it > if any help or programs were sent our way. We are planning to > archive all info we get, and will be more than happy to > retransmit as needed. > > Thanks, > Kevin Belles > I currently have a BIOS for CPM 3 that I am currently debugging a driver for the CCS 2422, I am using a Cromemco SCC for the CPU but drivers will be available for the CCS 2810, Its just matter of supporting the UART. If you are interrested in abtaing this BIOS from me send me EMAIL. I am not currently ready to make it public domain (lack of documentation) but if your still interrested contact me. The BIOS is designed to be modular with seperate drivers for the various supportted boards. Currently I have drivers for the Cromemco SCC, Cromemco TUART, Xebec S1410 hard disk controller, Xebec SASI interface board for the S100 bus, NCR 5380 SCSI controller chip. Kevin Flory @ Tolerant Systems, San Jose, CA.