clements@bbnccq.ARPA (Bob Clements) (08/16/86)
Version 11.7 of the W0RLI MailBox/Gateway has been released and is now available from SIMTEL20 as: Filename Type Bytes CRC Directory PD:<CPM.PACKET> PACKT117.ARC.1 BINARY 212704 0B69H This release is being distributed in ARC format because of the more efficient packing methods available. You can extract the files on your CP/M system using one of the following: Directory PD:<CPM.STARTER-KIT> UNARC.COM-Z80.1 BINARY 4096 C209H <--Z80 version UNARCA.COM-8080.1 BINARY 4736 DF9BH <--8080 version The changes since the last such posting, version 11.2, are summarized below in an extract from the CHANGES.TNC file. For those who have not seen this system before, a brief description: The W0RLI MailBox and GateWay is a system which runs on a Xerox 820 computer and which operates on Amateur Packet Radio via one or two TAPR TNCs (or clones). It also runs with TNC-2s. The W0RLI system is running at over 75 sites in some number of countries and makes up the majority of the packet mail forwarding system. It is also used for gatewaying between local packet areas and long haul links on HF, or to nearby nets on other VHF/UHF bands. For a more complete description, see NOTES.TNC. Hank is not on ARPANET or Usenet. I will be glad to relay comments and questions to him. However, he is also in the process of moving from W1-land to W6-land, so contact is not as solid as it has been. Also, he won't be doing much coding on this system for a while, for the same reason. If you would prefer to get this distribution on ready-to-run disks for your Xerox 820, send a self-addressed stamped 8" SSSD disk (in re-usable mailer) to K7PYK at the address below. Two disks if you want the sources as well. I will do the same under the same conditions. I am good in the Callbook. NOTE - Hank is no longer doing distributions himself. Wes, K7PYK, has kindly volunteered to take over that job. Please do NOT send disks to Hank. 73, Bob, K1BC ARPANET: CLEMENTS@BBN.COM Usenet: {ihnp4, decvax, linus, ...}!bbnccv!clements Packet: K1BC @ K1BC 145.09 and 221.11, near Boston [Extract of NOTES.TNC follows] W0RLI MailBox and GateWay Version 11.7 - 6/22/86 Page 1 Created for packet community by: Hank Oredson, W0RLI 19 North Hill Road Westford, MA 01886 Distributed by: Wes Morris, k7pyk 7422 E. McKinley St. Scottsdale, AZ 85257 Many people contibuted to this project, in many ways. In particular I would like to thank K1BC, KE1G, WB2MNF, W3IWI, WB7DCH K3RLI, KE3Z, K7PYK for their help and encouragment. These notes are rough, more release notes and tech notes than anything else. A SYSOPS Manual (Very nice, 40+ pages) is also available from Wes. It was written by Jon Pearce, WB2MNF. [Extract of CHANGES.TNC follows] W0RLI MailBox and GateWay Version 11.7 Changes and additions since version 11.6 are: Added 3 second delay between connect and sending "*** LINKED ..." Changes and additions since version 11.5 are: Added FL (File Local users) and FB (File BBS). Tag in config to enable/disable retention of "F" msgs on forward. Cleaned up the handling of tnc state changes with MailBox state changes. Changes and additions since version 11.4 are: Login procedure split from TNC.MAC into LOGIN.MAC Logic changed to allow local users to connect if "only bbs" flag set. If station connecting is a bbs: bypass # digi check, exclude checks. New tag in config to exclude connects thru digi with illegal call. Changes from k1bc (Thank you Bob ...) : LM now lists messages TO and FROM user. Changes and additions since version 11.3 are: Changes from k3rli (Thank you Ed ... ) : Help and Info files may be $sys. WN command for users. Message type "F" is never killed after forward, only marked. "Expert user" flag. No logoff message, short prompt. Changes and additions since version 11.2 are: BIOS common code now in files BIOS????.INC Attempt to upload existing file got error msg twice. Added EU with no argument prompt through all users for delete. Added K4NTA code to handle forwarding through a GATOR 2 PAD. Made UA available to remote sysop. [End of extracts]