dwa@hpfcla.UUCP (dwa) (10/19/84)
I recently purchased a Novation 212 upgrade board for my Apple IIe, so that I can transfer files at 1200 baud instead of the 300 baud rate on the standard Novation AppleCat modem. After using the Com-Ware software to set up the 1200 baud rate, it works just fine. However, when trying to use my P-Term software, it will only work at 300 baud. I have changed the CONFIG.TEXT for baud rate from "6" to "8" and used MAKEPTDATA to create a new PTERM.DATA file. Using the "B" selection on the secondary menu, I reset the baud rate to 1200--but when I dial up and connect is does an immediate disconnect. Changing the baud rate back to 300 with the "B" selection solves the disconnect problem, but the transmission rate is reduced to 300. Any ideas? Doug Anderson {ihnp4,hpfcla,hplabs!csu-cs}!hpcnoa!dwa