gtp@hounx.UUCP (G.PECKHAM) (04/22/86)
Help.... I have been trying to connect an amdek 500 color monitor to an Applied Eng. RGB card. So far I have tried two different cables and have had no success. Here's whats happening. I receive the picture but cannot get it to lock. It rolls top to bottom. By CAREFULL adjustment I can just about get it but not quite. Sounds like the vertical sync. Problem is that the amdek 500 works in both nstc and rgb modes. In the nstc mode it works fine. I would guess that the same vertical sync circuitry works for both ??? Does anyone have a similar setup (especially in Holmdel, so that I could test to see which component is bad - rgb card, cable, monitor)? Any advice will be appreciated. Thanks in advance Gary (201) 949-1831 or holmdel hounx!gtp