6056626@PUCC.BITNET (Jonathan Baker) (09/28/86)
A few years ago I bought a used Apple comm card (NOT Super Serial)
from my old high school, with intent to attach a modem. I wound
up with an internal 300bps modem, but now want to get an external
1200 bps modem, probably Volksmodem 12. I borrowed one from my
office and hooked it up with the //e and the comm card, and it worked
at 300bps. I don't know how to set it for 1200 bps, though, and would
rather not purchase another serial interface. Could someone tell
me how to set the baud rate and other things on the card, so I can
go and buy the new modem? Try mailing to me, but people seem to
have trouble doing that.
Jonathan Baker
6056626@pucc.BITNET (I think)polish@lexington.columbia.edu (Nathaniel Polish) (09/29/86)
I believe that the card you are refering to is the old Apple Communications card. It is a short card with a ribbon cable threaded through the end of the board. This is a 300 baud card only. This was one of Apple's first cards for the ][ series. Nat Polish@cs.columbia.edu