wtm@bu-cs.UUCP (W. Thomas Meier) (11/07/85)
Hello, I am looking for a termcap entry for a Data General Dasher D211/D210 terminal so that "it" will be able to talk to a VAX/VMS system running CCA Emacs. What I have tried so far, is sending control chars to put the terminal into ANSI mode as it logs into the VAX, then I change it back to a DG terminal when it calls up Emacs. I used the termcap entry that DG supplies with its MV10000 Emacs, but this has screen addressing problems and all I get is reverse vidio mush. The ANSI termcap is not much better. Any advise would be greatly appreciated. %------------------------------------------------------------------+ | W. Thomas Meier | | | |UUCP: ...!harvard!bu-cs!wtm | |ARPA: wtm%bu-cs.csnet@csnet-relay.arpa | |CSNET: wtm@bu-cs | |BITNET: ccwtm@bostonu.bitnet@wiscvm | +------------------------------------------------------------------% -- %------------------------------------------------------------------+ | W. Thomas Meier | | | |UUCP: ...!harvard!bu-cs!wtm | |ARPA: wtm%bu-cs.csnet@csnet-relay.arpa | |CSNET: wtm@bu-cs | |BITNET: ccwtm@bostonu.bitnet@wiscvm | |USMail: 8 Colborne Road, Brighton Ma. 02135 | |NYNEX: (617) 254-8033 | +------------------------------------------------------------------%