adm@cbneb.UUCP (04/08/85)
I have a vt220 which I run in VT100 mode most of the time. I do however have a couple of programs that will only run on a VT52. At the present time a run a short program to software switch from vt100 mode to vt52 mode, This works fine, but when I want to switch back to vt100 mode I can't. Has anyone found an escape sequence that will permit you to switch from vt52 mode to vt100 mode or even to vt220 mode without reseting the terminal??? I have check the vt220 programmers guide but have not found a solution. tnx Gary W. Sanders (N8EMR) ihnp4!cbnap!gws AT&T Bell Labs (Columbus,Ohio)
lew@t4test.UUCP (Lew Mullen) (04/19/85)
> ... Has anyone found an escape sequence that > will permit you to switch from vt52 mode to vt100 mode or even to vt220 > mode without reseting the terminal??? Doesn't "escape <" do that ? (escape, less-than) -- t4test!lew ( Lew Mullen @ Intel/Santa Clara )