allyn@sdcsvax.UUCP (Allyn Fratkin) (04/20/85)
I'm trying to change the baud rate on an AT&T 4425 terminal from the
host, but it doesn't seem to work correctly. This is on system V, but
I tried it on 4.2 BSD, and it still doesn't work.
I have a file (actually my .profile) that says:
echo "\033[1;3j\c"
stty 9600
The behavior I get is that the terminal doesn't change baud rates. BUT,
if I go into setup mode, the new baudrate I just set is
displayed, and when I come back out of setup, the new baudrate is in
effect. The host *does* change baudrates correctly.
Is this a known bug in the terminal, and is there any way around it?
Thanks,
--
From the virtual mind of Allyn Fratkin allyn@UCSD.ARPA or
UCSD EMU/Pascal Project {ucbvax, decvax, ihnp4}
U.C. San Diego !sdcsvax!allyn
"Generally you don't see that kind of behavior in a major appliance."